Part Number 167-4360, 310 Series Cable Assembly, Single-Ended Shielded On Teledyne Reynolds Inc.

Contact us at: (310) 823-5491

Request Information

Series 310 For Operation at Reduced Pressure
A sealed version of the series 31 that mates all series 311 Cond. 1 receptacles and adaptors.

Unit of Measure

Specifications | Body Properties | Cable Preparation

Series	N/A 310
Assembly Type	N/A Single-Ended Plug Cable Assembly
Altitude/Reduced Pressure Rating	N/A 70,000 ft.
Current Rating	N/A 10 Amp
Operating Temperature	N/A -40 to 85 ºC
Test Voltage	N/A 21 kVDC at 70000 ft. (simulated) and ambient temperature
Polarization	N/A Cond. 1
Mating Compatibility	N/A Mates series 311 Cond. 1 receptacles and adaptors.
Bayonet Coupling Nut Material	N/A Brass
Bayonet Coupling Nut Finish	N/A Nickel
Coupling Style	N/A Bayonet
END #1	N/A 167-4356
END #2	N/A Pig Tail
Sealed Receptacle	N/A N/A
Standard/Non-Standard¹	N/A Standard Part
Export Classification	N/A TBD
RoHS Compliant	N/A TBD
Voltage Rating	N/A 15 kVDC

Coupling Nut Material	N/A Brass
Coupling Nut Finish	N/A Gold Plated

N/A Reynolds Industries Inc. - High Voltage Connectors, High Voltage Cable Assemblies, High Voltage Wire, High Voltage Cable, High Voltage Capacitors

CLICK HERE FOR A PHOTOGRAPHIC "HOW TO" Series 310 (P/N 167-4356)
Step 1 Cut cable to length, clean and square. Slip boot and crimp sleeve over cable. Strip outer jacket to dimension shown. Trim exposed braid to dimension. Trim inner insulation to dimension. No nicked or severed strands allowed. Pot tin dip inner conductor using SN60 solder in accordance with J-STD-006. Remove all flux. Step 2 Solder contact in place through hole using SN60 solder in accordance with J-STD-006. No solder buildup allowed on contact outer diameter. Completed solder joint must have a continuous fillet of solder between the inner conductor and the contact. The solder in the feed hole must be free of pinholes and flush or below flush. Rear of contact shoulder shall be as flush as possible with insulation of cable core, but not to exceed .030". Flair braid by moving cable core in a circular motion. Step 3 Solder contact in place through hole using SN60 solder in accordance with J-STD-006. Completed solder joint must have a continuous fillet of solder between the conductor and the contact. The solder in the feed hole must be free of pinholes and flush or below flush. Rear of contact shoulder shall be as flush as possible with insulation of cable core, but not to exceed .030".

Download this page as a PDF for best print quality.

¹ Non-standard parts will have longer lead times and potentially higher pricing. Please contact Teledyne Reynolds Engineering department to determine feasibility for use in your application.

Series